|
Prelok Thread Sealant is a range of dry-to-touch non-reactive coatings applied to the threads of screws,
bolts, fittings or special components, eliminating the need for hand applied
tapes or liquid sealant.
Applied as a water based suspension which is oven dried, finished parts are
easy to handle and have no special storage requirements.
These processes offer high pressure sealing within the thread flank without any
increase in removal torque. During assembly the coating is compressed, filling
in all axial tolerances between the mating threads, creating a barrier against
water, oils, air and gases at high pressure.
Driseal 506 is a pale blue dry-to-touch coating of non-locking mineral fibres which upon assembly provide excellent sealing properties. The parts can be re-used or adjusted under controlled conditions.
Industry Approvals
Our sealant product is approved to a wide range of industry standards
including:- Ford WX201, Ford WSS-M18P12-A, Rover RES.22.FP.03, Varity
Perkins PMS P.1.04. Plus many other industry approvals.
Product Guide
We currently process a range of Headed Components, Studs, Plugs and similar size parts.
We can apply our coating to ferrous or non-ferrous materials (Steel, Aluminium, Stainless Steel, Brass and some plastic materials).
We offer a complete Plate and Patch service.
This is a general guide to the products we currently process. We are able to process other components subject to evaluation.
|
A. The Pre-applied process consists of
applying a thin film of sealant onto a defined
area of the male thread surface.
B. The coating is non-toxic, dry to touch,
ready to use and safe to handle.
C. Upon installation into the female threaded
component, a compressive force is developed,
forming a barrier against liquid, oils
and gasses.
|
